2/24/2024 0 Comments Instaling ProFindRegister your product warranty online at COMPLIANCE Please refer to warranty‑conditions for full warranty terms and conditions. To maintain a waterproof* /splash proof seal, ensure that the battery cap O-ring is periodically lubricated with silicone grease.Īlways check that the battery cap O-ring and screw threads are clear of dust, sand, and grit. One long beep followed by two short beeps will indicate when Factory Reset is complete. After two long beeps, continue to hold for 5 seconds. Factory Resetįrom off, press and hold the Power button (5). If + (6) or – (7) are not pressed at all when turning on the pinpointer, it will default to the last-use audio mode. To turn audio tones OFF, hold down – (7) when turning on the pinpointer. To turn audio tones ON (default), hold down + (6) when turning on the pinpointer. To disable Ferrous Tone ID, press and hold – (7) for 3 seconds, until the unit emits one long beep. Interrupted chirping tones upon detection indicate a ferrous target.įerrous Tone ID is effective when the probe is 10–15 mm (approx. When the pinpointer is close to the target: To enable Ferrous Tone ID, hold the pinpointer away from metal objects, then press and hold + (6) for 3 seconds. When minimum sensitivity is exceeded (level 1), there will be a long beep. When maximum sensitivity is exceeded (level 5), there will be a long beep. When the battery level is critically low, the pinpointer will automatically power off. Low Battery is indicated by a flashing LED* (3). If the pinpointer is inactive for another 5 minutes, it will automatically power off. This will repeat every 10 seconds unless a detection occurs. When the pinpointer is switched on but has been inactive for approximately 3 minutes, a long alert beep will emit. Three short beeps will emit and the pinpointer will power off. When the detected object is very close to the probe, the beep becomes a continuous tone. When a detection occurs, the vibration* will intensify, and the beeps will emit increasingly closer together. When auto-calibration is complete, a short beep indicates that the pinpointer is ready to use. The unit will beep twice and the LED (3)* will illuminate. Restart all programs for your changes to take effect.With probe at least 300mm/1' away from metal objects, press the Power button (5). Under Choose Display language, you can change the default display and help languages for all your applications. For more information, see Add a language or set language preferences in Office. You can change the default language for all your Microsoft 365 applications in the Set the Office Language Preferences dialog. Restart all programs for your changes to take effect. If the language accessory pack contained display and help for the language, you should see it listed here. Under Choose Display Language, you can change the default display and help languages for all your applications. If the status is Not installed, click the link to install the proofing tools. If the language accessory pack includes proofing tools for that language, the Proofing column shows Installed. Under Choose Editing Languages, make sure the language you want to use is added to this list. In any Microsoft 365 application, go to File > Options > Language. This configuration affects all your Microsoft 365 applications. Kà bí o ti le ṣàtòpọ̀ àkópọ̀ náà lẹ́yìn àgbékalẹ̀.Īfter you install the language accessory pack, you must configure Microsoft 365 for your new language preferences. Serbian (Cyrillic, Bosnia & Herzegovina).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |